Conformal Coating Drying Cabinets FAQs

Can the CC100 Curing Cabinet be used at higher temperatures?

What are the extraction rates for the CC100 drying cabinet?

What are the exact dimensions for the CC100 drying cabinet?

Can the CC100 drying cabinet be used at higher temperatures?

The CC100 system as an ambient temperature cure cabinet for wet coated PCBs. The purpose of the cabinet is to take away harmful solvents and keep dust away from the PCBs.

What are the extraction rates for the CC100 drying cabinet?

As far as the Drying Cabinet is concerned, extraction rates required are minimal with the doors closed

because whilst the system is not a sealed cabinet the gaps around the doors and the introduced louvre vents necessary, offer limited airflow - just a gentle continuous removal of the heavier than air solvents,

at somewhere less than 100 cfm.

With the doors open you would be looking at a rate approaching 2000 cfm which when in use would be excessive and could cause more harm than good with an over accelerated drying rate and dust / airborne contamination.

What are the exact dimensions for the CC100 drying cabinet?

The dimensions for the system are as follows:

External dimensions      1005 x 625 x 1845mm  (w x d x h)  645mm deep including hinges 39.6 x 24.6 x 72.6inch  (w x d x h)  25.4inch deep including hinges Depths do not include extraction fittings. Internal dimensions  950 x 600 x 1800mm  (w x d x h)    37.4 x 23.6 x 70.9inch  (w x d x h)  915mm  (36inch) opening between the doors when fully opened should you want to slide a board holding PCB’s straight in.

Shelf dimensions 940 x 450mm   (w x d )  37.0 x 17.7inch  (w x d ) Shelf Spacing   90mm (3.5 inch) between brackets  -  55mm 2.2 inch) between shelves 19 shelf capacity – 86.4 sq. ft  total when PCB’S horizontal but because they are welded mesh they have the capacity to hang dipped boards vertically using craft paper to line the shelves and collect the drips. The shelves are made from1"(25.4mm) square welded mesh using 3.00mm approx. copper coated mild steel wire, bent and powder coated.